Riing 12 RGB High Static Pressure LED Radiator Fan (3 Fans Pack)

Specially made for those seeking a 120mm PWM fan with superior airflow, silent operation, and RGB lighting, the fan utilizes compression blades, hydraulic bearing, and a patented 256 colors LED ring, lighting up your system without sacrificing performance.

C1000 Pure Clear Coolant

Made in Germany, the non-flammable clear coolant is a ready-to-use cooling solution with at least 3 years shelf life in airtight containers, providing great performance while preventing the entire cooling system – copper, brass, nickel, and aluminum – from corrosion.

Pacific G1/4 90 Degree Adapter – Chrome

 

Finished in chrome-plated copper, the adapter fitting is in 360° revolvable design, and consists of two sealed O-rings, allowing users to redirect the fittings at a 90-degree angle for easier tube routing. 2 adapter fittings are included in the kit.

V-Tumbler PETG Tube 5/8” (16mm) OD 500mm (4 Pack)

Manufactured from premium PETG, the rigid tubing provides custom PC water cooling configurations with reliability and durability from end to end.

 

Cautions

 

Thermaltake recommends the following steps to be taken before using the Pacific series radiators and water blocks

1. To ensure a clean loop, flush and rinse your radiators and water blocks with distilled water prior to use.
2. Do not use tap water or distilled water as your coolant, it may harm your loop and reduce performance.
3. It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while protecting the entire liquid loop from corrosion.
4. Before storing your water cooling components, please clean, rinse and dry. This will ensure a longer lifespan for your components.

Thermaltake recommends the following steps to be taken after completing your water loop setup

1. It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while preventing the entire cooling system – copper, brass, nickel, aluminum, and steel – from corrosion.
2. Fill the reservoir with coolant and cycle the power on and off several times while the pump pushing the coolant into the loop.
3. DO NOT let the pump run dry when there is no liquid entering the pump turn off your power immediately
4. Fill the reservoir to the top as it will prevent air from going into the pump
5. If necessary tilt the system slightly from side to side to bleed the air out of the loop.
6. Place some paper towels under fittings and joining points to test for leaks.
7. Run the loop with the fill port opens for about 24 hours to completely bleed the air out of the loop.
8. Before starting, flush out your system correctly to prevent any coolant or unwanted particles from sticking to your tubes, radiators and other cooling components.
9. Coolant might fade over time.